۱۳۹۲/۱۱/۲۱, ۰۳:۴۱ ب.ظ
حتی وقتی یک مدل جدید میسازم باز هم کار نمیکنه و این ارور رو میده
Warning: Using a default value of 0.2 for maximum step size. The simulation step size will be equal to or
less than this value. You can disable this diagnostic by setting 'Automatic solver parameter selection'
diagnostic to 'none' in the Diagnostics page of the configuration parameters dialog
less than this value. You can disable this diagnostic by setting 'Automatic solver parameter selection'
diagnostic to 'none' in the Diagnostics page of the configuration parameters dialog